Best answer: How do you check the transmission fluid on a 1999 Chevy Silverado?

Do you check transmission fluid with truck on or off?

Park vehicle on level surface, engage parking brake and start engine. Leave car in neutral or park. Let engine warm up and continue to run throughout operation unless vehicle’s owner’s manual says otherwise. (Be aware that some automatic transmission fluid levels are checked with the engine off.

Should transmission fluid be checked with engine running?

Step 1: Leave the engine running and open the hood to your car. The car must be warm when you check transmission fluid. Step 2: If you have an inline engine, look behind your oil dipstick, toward your windshield, to locate the transmission fluid dipstick.

Do you check transmission fluid hot or cold?

Transmission fluid expands in heat and in order to receive accurate results, it must be under normal operating conditions. If the fluid is checked when the engine is cold, you may get false results indicating the fluid is low. Allow the engine to continue running while you check the level.

IT IS IMPORTANT:  Are all 46re transmissions the same?

What are the signs of low transmission fluid?

Signs of Low Transmission Fluid

  • Noises. If your transmission is working properly, you shouldn’t hear any noise while you’re driving as it should transition smoothly. …
  • Burning Smell. Any foul smell coming from your car should direct you to your nearest service center. …
  • Transmission Leaks. …
  • Slipping Gears.

What’s the proper way to check transmission fluid?

Check the Level

With the engine warmed up, leave the car idling in park on a level surface. Pull out the dipstick, wipe it clean, replace it slowly, and then pull it back out. Check the fluid level—how high the fluid comes up on the dipstick—against the “full” and “low” or “fill” marks on the dipstick.

Where is the transmission dipstick?

– On rear-wheel drive vehicles, the dipstick is usually on the passenger side of the engine compartment, near the back of the engine. – On front-wheel drive vehicles, the dipstick is usually on the driver’s side, on one side of the transmission.

What happens if you add too much transmission fluid?

Excess transmission fluid can cause several adverse effects to the transmission. If the fluid stays above the recommended level, it can cause it to start mixing with air. This can lead to gear slippage, hard shifting, and other transmission shifting issues.

How do you check the transmission fluid on a 1999 GMC Sierra?

Here’s How to Check Transmission Fluid in Your Car

  1. Make sure your car is in park. Turn on your engine and let it warm up for a few minutes. …
  2. Locate the transmission fluid dipstick. …
  3. Remove the dipstick and touch the fluid, moving it around between your thumb and forefinger. …
  4. Use a rag to wipe off the dipstick.
IT IS IMPORTANT:  Can you run a boat motor without water?

How do you check the transmission fluid on a 1995 Chevy Silverado?

You have to warm up Your Chevy Silverado and leave it running. On the back of the engine, You’ll see the dipstick in a long tube that goes to the transmission. You check that with the engine warm and running. The ATF should be in the crosshatched marked area on the dipstick.

What kind of transmission fluid does a 1998 Chevy Silverado take?

The type of transmission fluid used by the chevy silverado is carquest dexron®-vi full synthetic atf.